3Com Wireless 11n Guia De Instalacion página 3

ABOUT YOUR ROUTER
The front panel of the router contains a series of indicator lights (LEDs) that help describe the state of
various networking and connection operations.
1. Power LED (Illuminated Logo) White
Indicates that the Router is powered on. If this LED is off, the power adapter or the connections to the
power adapter may be faulty. Refer to the Problem Solving section.
2. Alert LED Amber
Indicates a number of different conditions, as described below.
Off - The Router is operating normally.
Flashing quickly - Indicates one of the following conditions:
•
The Router has just been started up and is running a self-test routine, or
•
The administrator has invoked the Reset to Factory Defaults command, or
•
The system software is in the process of being upgraded
In each of these cases, wait until the Router has completed the current operation and the Alert LED is
Off.
On for 2 seconds, and then off - The Router has detected and prevented a hacker from attacking your
network from the Internet.
Continuously on - A fault has been detected with your Router during the start-up process. Refer to
the main User Guide.
3. Cable/DSL Status LED Blue
Indicates that the internet connection to the Cable/DSL modem is active. If the LED is flashing, data is
being transmitted or received by the modem.
4. Wireless LAN (WiFi) Status LED Blue
If the LED is on it indicates that wireless networking is enabled. If the LED is flashing, data is being
transmitted or received. If the LED is off, the Wireless LAN has been disabled in the Router, or there is
a problem.
Refer to the 'Problem Solving' section.
3
All manuals and user guides at all-guides.com