Blade Assembly; Light Kit Assembly (Optional). Pgs - Craftmade DE52CH4 Guia De Instalacion

9. Blade Assembly.

Time Saver: Washers for blade screw
attachment can be set on each blade screw
prior to installing blades.
Locate 12 blade attachment screws and fiber
washers in one of the hardware packs. Hold
blade arm up to blade and align holes. Insert 3
blade attachment screws (along with fiber
washers) with fingers first and then tighten
screws securely with a Phillips screwdriver.
Repeat procedure for the remaining blades.
Locate 8 blade arm screws and lock washers in
one of the hardware packs. Align blade arm
holes with motor screw holes and attach blade
arm with lock washers and blade arm screws.
Before securing screws completely, repeat
procedure with remaining blade arms. Secure
all screws.
Note: Tighten blade arm screws twice a year.
10. Light Kit Assembly (Optional).
If you wish to use your fan WITHOUT the light
kit, locate the metal cover. Next, locate flat
washer in one of the hardware packs and place
flat washer on threaded rod at bottom of motor
assembly. Carefully arrange molex connections
inside hole in center of metal cover. Align hole in
center of metal cover with threaded rod. Turn
metal cover to the RIGHT (clockwise) to secure
metal cover. Please proceed to Section 11 on page
10 to complete installation.
If you wish to use your fan WITH the light kit,
locate wing nut in one of the hardware packs.
Align hole in middle of fitter plate with threaded
rod at bottom of motor assembly, allowing the
molex connections from motor assembly to
come through hole in middle of fitter plate. Use
wing nut to attach fitter plate to motor assembly.
["Light Kit Assembly" continued on next
page.]
lock washers
flat washer
page 8
motor
housing
blade attachment
screws and washers
J
blade arm
blade arm screws
motor assembly
threaded rod
metal cover
motor assembly
threaded rod
fitter plate
wing nut
blade