Customizing Vacuum Time; Vacuum Pulse Operation - Weston Pro-3500 Instrucciones

CUSTOMIZING VACUUM TIME

1.
Press the Vacuum Time button. The button will illuminate (if you do not
adjust the time within 3 seconds, the light will turn off)
2. Use the +/- buttons to adjust the vacuum time to your preference (in
seconds).
3. Apply light pressure to the lid. Press the Start button. The vacuum time
light will no longer stay illuminated. The pump will begin removing air while the
LED Vacuum Time Monitor begins to count down.The monitor will count down
starting at your chosen setting until the air is completely removed from the bag.
4. The bag sealing process will now automatically begin. The LED Seal
Time Monitor will begin to count down either from the default recommended
time of 3 seconds, or the Seal Time that you set.
5. Once the Seal monitor has reached 0, the sealer will automatically stop the
pump and release vac pressure.
270mm x 80mm Permanent Plastic Label

VACUUM PULSE OPERATION

1. Press and release the pulse button. The pump will engage each time you
press the button. Air will gradually be removed. Continue to press the button
until you have removed the desired amount of air.
2. Press the Manual Seal button to seal your bag.
3.
The bag sealing process will now automatically begin. The LED Seal
Time Monitor will begin to count down either from the default recommended
time of 3 seconds, or the Seal Time that you set.
4. Once the Seal monitor has reached 0, the sealer will automatically stop the
pump and release vac pressure.
270mm x 80mm Permanent Plastic Label
Do not attempt to pull the lid open before the vacuum has been released. Always wait at
least 30 seconds before sealing another bag to avoid overheating. Leave lid open to allow
seal bar to cool more quickly.
Vacuum Time Vacuum
Adjustment Monitor
Manual Seal
Vacuum Pulse
button
button
13