Installation Guide - AO Smith AO-US-200 El Manual Del Propietario

STEP 1 Install Brass Tee and Connect Tubing
Install Brass Tee
1. Turn off COLD water supply.
2. With an adjustable wrench,
disconnect supply line.
3. Attach brass tee (B) to shutoff
valve and re-attach COLD
water line to brass tee.
Connect Tubing
1. Attach white tube (A) to the brass tee
(B). Slide brass nut (C) onto the tubing
with threads of nut facing end of tube.
2. Slide one plastic collar (D) onto the tube.
3. Place brass tube insert (E) into opening
of tube.
4. Push tip of tube into opening of
brass tee.
5. While holding tube in place, tighten
brass nut to compress plastic collar
and create a seal.
STEP 2 Faucet Installation and Connection
Faucet Installation
Place faucet rubber washer (F) between
faucet and sink. Under the sink, thread
the faucet spacer (G), faucet washer (H),
and faucet nut (I) onto the tubing. Tighten
faucet nut to secure faucet to sink.

INSTALLATION GUIDE

2
1
3
Note: Avoid over-tightening.
NEED HELP? GIVE US A CALL 877.333.7108
2
3
1 2
4 5
F
G
H
I