Assembly
Attaching Leveling Feet
1. From the loose parts bag find the following items:
4
Leveling feet
8
Hex nut 3/8-16
2. From the loose parts find the following items:
4
Leg
3. Put a hex nut on each of the leveling feet and screw it
down towards the rubber foot.
4. Put the leveling feet through the holes in the bottom of
each leg.
5. Put another hex nut on each of the leveling feet and
hand tighten until they are next to the bottom support
of the leg.
WARNING: After the band saw has been attached
to the legset, it will be necessary to adjust the lev-
eling feet so the saw does not rock.
Assembling Leg Set
1. From the loose parts bag find the following hardware:
40 Carriage Bolts M8 x 1.25-16
40 M8 Washers
40 M8 Lockwashers
40 M8 Nuts
2. From the loose parts find the following items:
4 Legs (With Attached Leveling Feet)
2 Stiffeners (short)
2 Stiffeners (long)
1 Stand top
3. Place stand top upside down on a level surface. Fasten
four legs to top using carriage bolts, washers, lock
washers, and nuts, as shown. Note: Legs fasten to
outside of top. Do not tighten at this time.
4. Fasten two long stiffeners and two short stiffeners to
stand legs using carriage bolts, washers, lockwashers,
and nuts, as shown. Finger tighten only at this time.
Leveling Foot
Washer M8 Lockwasher Nut Hex M8
Bolt Carriage
M8 x 1.25-16
Legs
Stiffener (Long)
Washer
Carriage
Bolt
Leg
Stand Top
10
Hex Nut 3/8-16
Leg
Leg
Hex Nut 3/8-16
Leveling Foot
M8
Stand Top
Stiffener (Short)
M8
Lockwasher
M8
M8 Nut
Stiffener
Stiffener (Long)
(Short)