Brandson Equipment 304522 Manual Del Usuario página 11

4. Clearing the memory (recommended each time before reprogramming)
1. Press the A and B buttons simultaneously until the LED flashes three times.
2. Release the B button (press and hold the A button), and press the B button
three times. The LED flashes rapidly.
3. Release both the buttons. The garage door opener is ready for copying.
5. Duplication
When duplicating, place the duplicator as close as possible to the desired original
transmitter (a little to the side (Pos.1 or Pos. 2 or Pos. 3) if there are problems
with the connection).
Pos.1
6. Duplicating the individual buttons
Keep the desired button of the original transmitter pressed and then press the
button to which you want to copy the signal. The status led flashes briefly. Press
and hold the button until the LED of the garage door opener flashes again. This
means that the duplication was successful.
English
Pos.2
Pos.3
11