Husky 28WC01BP-THD Manual Del Operador página 8

GROMMET INSTALLATION
Items Needed:
JJ - Grommet (Qty: 2)
Process:
• Place the grommets JJ in the holes in D and G.
Figure 12
FINAL MOUNTING OPTION 1
Process:
Note: Option 1 is for hanging cabinet on Husky®
Trackwall. If hanging cabinet directly on wall,
go to option 2.
• With assistance hook bracket H over Trackwall and
slide down into place.
Note: Unit cannot be placed over a Joiner Section of
Trackwall. Unit must be hung either left or right of the
Joiner and then slid over the joiner.
Hook over Trackwall and
slide down into place.
Figure 13
Bracket-Wall
JJ
FINAL MOUNTING OPTION 2
Items Needed:
Mounting hardware as defined by your local building
code.
Process:
• Align Wall Cabinet with studs.
• Mark and drill (2) 1/8-in pilot holes. Note Use outside
holes for mounting to studs on 24-in centers. Use inside
set of holes for mounting to studs on 16-in centers.
• Attach Wall Cabinet to studs using appropriate hardware
as defined by your local building code.
16-in centers
24-in centers
Figure 14
LOCKING AND UNLOCKING THE UNIT
Locking the Unit:
• Make sure doors are fully closed.
• Insert the key and turn fully to the left.
• Remove key.
Unlocking the Unit:
• Insert the key and turn fully to the right.
• Remove key.
SHELF ADJUSTMENT
• Empty shelf.
• Remove fasteners.
• Rotate shelf upward and pull forward, as shown.
• Move shelf to desired location.
• Insert back of shelf in notches, rotate shelf into place
and reinstall fasteners.
8
OPERATION