Installation And Use Of The Child Safety Seat; Installing The Child Safety Seat (Group 0+: 0-13 Kg) - Teamtex Seaty 360 Manual Del Usuario

EN

5. Installation and use of the child safety seat

5.1 Installing the child safety seat (Group 0+: 0-13 kg)

Installation method no.1: ISOFIX + Top-Tether
For children weighing up to 13 kg, REAR-FACING installation.
Step 1: First of all, adjust the seat to its most inclined position then swivel the child
safety seat to a rear-facing position. Place it on the seat of your vehicle (refer to points 4.8
and 4.9).
Step 2: Use the ISOFIX clips to fasten the child safety seat in place. Make sure they are
properly locked, the indicators for each clip should be green.
Then push the child safety seat back until it comes into contact with the backrest of the
vehicle's seat (refer to points 4.6 and 4.7).
Step 3: As illustrated below, pass the Top-Tether over the headrest of the child safety seat
(1). Attach the hook to the fastening point of your vehicle (fastening point indicated in you
car's user manual) (2). Tighten the Top-Tether as much as possible (3). The Top-Tether
indicator will become green when the Top-Tether is sufficiently tightened.
Step 4: Place your child in the child safety seat, use the 5-point harness to secure your child.
Buckle and properly tighten the harness, make sure the straps are not twisted and that the
height is adjusted to suit your child (refer to points 4.2, 4.3, 4.4, 4.5).
28