FAME CHALLENGER SUB 18A Manual De Usario página 7

> The electrical installation of the relevant area complies
with the requirements of the IEC (ANSI) standards.
> The device was used following the in-
structions of the user's manual.
• This product has been optimized for the use with
music and speech signals. The use with sine,
square or other measuring signals at high le-
vels can cause serious damage to the device.
General Safety Information for Speaker Systems
Mounting systems should be used exclusively with the
loudspeaker systems authorized by the manufacturer
and the mounting accessories mentioned in the
installation instructions. The installation instructions
from the manufacturer should always be followed. In the case
of incorrect installation or the use of non-approved mounting
accessories, the load cannot be guaranteed and no liability is
assumed by the manufacturer.
Should changes be made to the speakers, installation accesso-
ries, connection and fastening elements or lifting equipment
and slings, the load carrying viability of the system can not be
guaranteed and no liability is assumed by the manufacturer.
Repairs made to safety relevant components may only be under-
taken by the manufacturer or authorized personnel; otherwise
the operating authorization is void.
Installation must be carried out exclusively by
qualified personnel and exclusively at assembly
points with sufficient load-bearing capacity, while
also conforming to local building regulations. The
mounting materials (screws, dowels etc.) prescribed by the
manufacturer in the installation instruction must be used.
Bolted connections must be secured against loosening through
appropriate measures.
Fixed or mobile installations (in this case speakers
incl. mounting accessories) must be secured with
two independently acting safety mechanism against
falling. Loose fittings or components and parts that
become detached must be able to be collected by appropriate
equipment. National Regulations must be observed with the
use of connection and installation elements as well as lifting
equipment and slings. With regard to the assessment of safety
precautions, the results of dynamic loads (jerk forces) are to be
taken into account.
The maximum load capacity is to be observed with
stands. Additionally, please note that stands are
constructed and approved to carry the load in the
structural centre. Stands must be placed upright on
solid and stable foundations. Stands must be secured additio-
nally by suitable measures, if for example:
> the foundation surface does not allow for a stable stand.
> the height restricts the stability.
> exposure to strong winds is expected
> the possibility exists for the stands to
be knocked over by people.
Special measures may also be required as a precaution against
endangering spectators. Stands must not be placed in escape
routes. In the case of stands being placed in roads, regulations
concerning the width of the road as well as the appropriate
closing off of the road with the correct signage thereof must be
followed. Lifting, moving and placing back down exposes one
to risk. To this end, appropriate tools should be used. In this
case, national regulations must be followed.
During installation, protective clothing should be
worn and equipment used at all times (especially
head protection, gloves and safety shoes) and only
suitable lifting equipment (ladders, scaffolding) should
be used. The responsibility for this lies solely with the installer.
ATTENTION!
After installation the mounting system and the
speakers must be checked for a secure hold. The
operator of the speaker systems (fixed or mobile) is
obligated to check or to have checked all system components
on a regular basis, taking into account the respective national
regulations and to immediately eliminate potential damage.
Furthermore, we strongly recommend detailed documentation
of all control measures.
Wind loads, snow and ice loads as well as thermal effects
are to be taken into account for the stability and viability of
loudspeaker systems which are permanently, or for long periods
of time, located outdoors as well as the structures and surfaces.
In particular, the load bearing points of flown systems should be
dimensioned as too allow for sufficient safety reserves. In this
case, national regulations are always to be followed.
• Please consult the manufacturer to see if your
speakers are suitable for outdoor use.
Professional loudspeaker systems are capable of
producing sound levels high enough to cause
hearing damage. Even exposure to seemingly mild
and harmless sound levels over prolonged periods of
time can cause permanent hearing damage (from 95 dBA SPL)!
Therefore we recommend that anyone who is exposed to high
sound levels to wear professional hearing protection (ear plugs
or capsule headsets).
Manufacturer: Music Store professional GmbH, Istanbul-
straße 22-26, 51103 Cologne, Germany
7