Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
lost of one of the contact during
the cleaning phase; in this
case, it is possible to activate
the electronic bypass function
by pressing the granita-cold
drink selection button
the augers start turning again.
In this situation, if you lift the
cover, the augers keep on
turning and the keyboard block
is deactivated; this is why the
electronic bypass is to be
considered only as a temporary
remedy and not as a definitive
solution which is, instead, the
substitution of the defective
contact or the installation of the
lost one.
Once the contact has been
substituted or installed again,
use the following procedure in
order to deactivate the
electronic bypass:
Lift the cover: the augers go
on turning;
Stop the augers pressing the
button;
If you press the
press the
button: the
augers will turn;
Wait for the augers to stop,
and then release the two
buttons;
Replace the cover: the
auger will start moving
again.
System has been reset.
Self-diagnostics
Consult the Problem Solving
Section.
Configuration memory
All the functioning modes and
the regulations set are
registered in a non-volatile
memory which is active even
without power; therefore, when
you switch on the machine, the
tank keeps the configuration it
had when you switched it off, a
part from the keyboard lock (as
already said).
until
Minimum level signal
All machines are endowed with
a probe that detects the product
minimum level in the tanks.
When the product is below this
level, the light of the lamp starts
blinking. If the product level
does not change, the light will
stop blinking after a minute.
How to start the
production of slush,
sherbets or cold drinks
Clean the machine as
described in the previous
paragraph.
Remove the covers and pour
the mix in the tanks.
Warning: When switching on
button,
the machine, the poured
product must not be lower
than 10 °C in order to allow a
correct calibration of the
electronic kit.
Switch on the main switch (see
pic. 7 in appendix-91).
Switch on the augers switch
.
Press the
to select "slush"
lighting ) or "cold drink"
(cold drink led lighting).
In "slush" mode, in order to
increase the product density,
use the
button, in order to
decrease it, use the
In "cold drink" mode, in order to
increase the product
- 21 -
temperature, use the
in order to decrease it, use the
In order to turn on the lamp
light, press the
Here you are the table with the
correspondence between the
values on the display while in
"cold drink" mode and the °C/°F
degrees.
Warning: in order to have
slush, sherbets or cold drink,
you need a small quantity of
recommended quantity is
usage instructions. In case of
natural products, we suggest
to use a quantity that goes
blocked because of ice blocks
due to a lack of sugar or to
other reasons, such as foreign
bodies in the tank, the vertical
auger can undergo a break.
Warning: If the temperatures
exceed 35°C Solera is not
button in order
refrigerator performance
(slush led
(that will be slower) and for
the correspondence between
the temperature selected on
the electronic board and the
button.
button,
button.
button.
°C
°F
2
2 – 6
35.6 – 42.8
3
3 – 7
37.4 – 44.6
4
4 – 8
39.2 – 46.4
5
5 – 9
41.0 – 48.2
sugar per liter. The
generally reported in the
from 12 and 22%.
If the horizontal auger is
responsible for the
drink temperature.
Publicidad
Tabla de contenido
