Long Feet; Granizadora Digital Silver Controls And Signals - Solera Eco Manual De Empleo Y De Mantenimiento

Long feet

(only for 115Vac/60Hz)
The units Granizadora Digital 2
and Granizadora Digital 3 with
voltage 115Vac/60Hz are
equipped with 4 long feet (4
inches) that must be installed at
the place of the short 4 feet
already mounted.
This installation is obligatory in
conformity of NSF rules.
This long feet aren't adjustable
in height.
Granizadora Digital
Silver controls and
signals
When you switch on the
electronic board, the display will
show
ELMECO / ITALIA
(0.15)
Where 0.15 indicates the tank
review number.
GD Silver has a ECO version
that only has the electronic
board like the one shown
before, and an ADVANCED
version that ha san additional
electronic kit in the machine
with additional features
connected to time.
Warning: The screen with the
"/" symbol indicates that the
values are shown
alternatively.
After the screen shown above
the initial screen will be
displayed:
- 22 -
StandBy
Press
WARNING: The electronic
board will keep the settings it
had when the machine was
switched off.
When the tank is in stand-by
mode, the augers and the
cooling system are off. The
augers and the gear motor can
be turned on by pressing the
button. The screen will
show:
Motor on
Press < <> >
If you press the button, the
screen will display as follows:
COLD
YY
(where YY is a variable number
between 02 and 05 for Cold
Drink Mode, which indicates the
temperature in °C at which the
product must be prepared).
Using and you can
increase or decrease the
temperature of the product. The
recommended temperature is
4°C.
If you press the button, the
screen will display as follows:
SLUSH
*
X
(where X is a variable number
between 1 and 9 and indicates
the density of the slush). If you
use the and buttons it is
possible to increase or
decrease the slush density
value.