How To Start The Production Of; With Gd Silver - Solera Eco Manual De Empleo Y De Mantenimiento

CLEANING
REQUIRED
Clean the tank as described in
the usage manual pag. 19;
In order to stop the warning
signal, press the
button; thus the count down will
start again for the next warning.
000d = time in days for the
cleaning warning to appear
- --- = count down (day to the
warning)
EXEMPLES:
100d = after 100 days the
machine will inform that it must
be cleaned up
050d = after 50 days the
machine will inform that it must
be cleaned up
007d = after 07 days the
machine will inform that it must
be cleaned up.
REFILL
ON / OFF
For machines with auto refill set
up ONLY! (This should be ON
only if the machine has the auto
refill installed). In this screen
you can activate or deactivate
the auto refill control signal.
Alarms functions
Granizadora Digital Silver is
endowed with a direct signalling
of the problems found. When
the electronic board blinks, it
indicates that there is an active
alarm. To see what alarm is,
please press the
button for 1 second.
In the "Problem Solving"
section, you can see a
complete list of all possible
alarms at pag. 29.
If more than one alarm is
active, these will be indicated
with more messages that
appear alternatively.
How to start the
production of slush,
sherbets or cold drink
with Granizadora
Digital Silver
Clean the machine.
Remove the covers and put the
mix in the tanks.
Warning: the temperature of
the poured product must not
be lower than 10 °C in order
to allow a correct calibration
of the electronic kit that will
be indicated as described in
the previous paragraph.
Switch on the main switch (see
pic. 7 in appendix-91).
Switch on the auger switch
.
The following screen will be
displayed:
Motor On
Press < <> >
Press the button to select
"slush" or "cold drink".
With the "slush" mode, you can
increase the product density
with the button and
decrease it with the
With the "cold drink" mode, you
can increase the product
temperature with the
and decrease it with the
button.
- 25 -
Cold drink.
It is possible to change the
product temperature from +02
°C to +05 °C using the
buttons to increase or
decrease it respectively.
Warning: The recommended
temperature value is 4°C.
*
Slush.
It is possible to change the
product density from 1 to 9
using the
increase or decrease it
respectively.
button.
button
COLD
05
or
SLUSH
5
or buttons to