Fit The Blade Guard; Connect The Hydraulic Unit - Husqvarna WS 460 Manual De Instrucciones

Fit the blade guard

WARNING! Never mount or dismount the
!
blade or blade guard without first switching
off the hydraulic unit and disconnecting the
hydraulic hoses running to the saw unit.
Carelessness can result in serious personal
injury or even death.
1 Slip in the blade guard guide between the stays on the
blade guard. Place the blade guard guide in the middle.
Lock the plastic heel on the handle to the upper stay on
the blade guard.
2 Make sure that the pivot arm is positioned vertically. Lift
the blade guard over the blade and hang the guard in the
blade guard holder on the saw. Exercise care so that the
runners on the blade guard are positioned in the slots on
the water block.
3 Lock the blade guard by pulling the handle out of the
guard and then down towards the saw unit so that the
latch locks the handle.
ASSEMBLY
4 To remove the guard, release the latch and pull the handle
upwards and inwards to the guard. Lock the plastic heel
on the upper stay.

Connect the hydraulic unit

Please read the operator´s manual supplied with the hydraulic
unit before using the machine.
When the saw unit, the blade and the blade guard are
mounted, the hydraulic hoses and the water cooling should be
connected.
The pressure hose from the hydraulic unit shall be connected
to the connector next to the start/stop switch for the blade
rotation.
P=Pressure
T=Tank
W=Water
Adjust the flow to the saw unit for the desired speed of the
blade. See the table in the chapter Technical data.
CAUTION! Max. flow to the saw unit is 27 GPM.
IMPORTANT! This machine is intended for use together
with a Husqvarna PP 3300, Husqvarna PP 2525 and
Husqvarna PP 2325. If the saw is used with another
hydraulic unit, the unit must be compatible with the
conditions required by the saw.
– 13
English