Track 400 Series - Husqvarna WS 460 Manual De Instrucciones

Adjusting the locking handle
As the saw wears, the locking handle may need to be adjusted
if play is noticed between the saw head and the saw carriage.
To adjust the locking handle, loosen the two top 6 mm socket
head setscrews (one on each side of the handle mount). Turn
the eccentric bushing with the supplied adjustment tool until
the cam lies tight against the saw head. Tighten the top 6 mm
socket head setscrew. Adjust the other side. Remove saw
head and tighten the lower 6 mm socket head setscrew on
both sides.
Adjusting the friction stop
The friction stop must momentarily support the combined
weight of the saw carriage and saw head when mounted on
the track with the track mounted vertically to the wall.
To adjust the friction stop, remove the saw head from the
carriage. Mount the carriage on the track and turn the friction
stop setscrew clockwise to apply additional force of friction.
The friction stop only needs to support the carriage and saw
head until the mating gears engage.
16 –
English
SETTINGS AND ADJUSTMENTS

Track 400 series

Adjusting the guide wheels
In order for the saw to run stably and saw a straight cut, the
four guide wheels must rest against the rail and not have too
much play. When there is too much play between the saw
carriage and rail the guide wheels must be adjusted:
The two marked guide wheels have eccentric axles and by
turning these the carriage is tightened onto the rail.
Start by loosening the marked nuts (1) with the supplied
special tool. Now loosen the two stop screws (2). When these
are loose, adjust the guide wheels (3) against the rail by
turning them towards the rail so the play is taken up. Hold the
guide wheels and screw in the stop screw. Now screw on the
nuts to secure the guide wheels in the new position.
2
3
Adjust the saw carriage
As the saw wears, after a number of hours working, it can be
a good idea to ensure that the saw sits firmly in the saw
carriage and rail. If not, the handle probably needs adjusting:
Loosen the marked (1) socket headed screw (one on each
side of the handle). Now turn the eccentric axles (2) with the
help of the supplied special tool until the axle lies tight against
the saw. Now tighten the socket headed screw.
1
1
2
3