Part Names And Functions - Panasonic AG-CA300G Instrucciones De Funcionamiento

Part Names and Functions

3 2
1. DC IN 24 V connector
This is the power supply connector for the
unit.
This is a DC 24 V supply connector from the
base station to the unit.
2. VF OUT connector
This is the connector to the LCD monitor
(BT-LH80W/WU; optional) and AG-YA500G
(optional).
The output is switched between the return
signal from the base station and the video
signal being recorded with the camera
recorder.
Connect with the LCD monitor using the
included dedicated cable.
Refer to the operating instruction of the
AG-YA500G when the AG-YA500G is used.
For details of signals for the VF OUT
connector, refer to [About the RET Signal]
(page 13).
<Note>
When the base station is connected to the
remote control unit and the AJ-HDX900P/E,
video for the recording is not output when the
remote control unit is turned off.
INCOM
1
10
9
8
3.
4.
5.
VF OUT
CALL
RET
BS
IN OUT
RET
REMOTE
CTRL
7 6 5 4
Intercom connector
Connect the headset for the intercom. Only a
dynamic microphone can be used.
The length of the cable to be used should be
3 meters or shorter.
REMOTE connector
This is a connector to transmit/receive the
control signal between the base station and
the camera recorder.
Connect with the REMOTE connector of the
camera recorder using the included
REMOTE cable.
Camera recorder is controlled using the
remote control unit connected to the base
station.
<Note>
Power of the unit will not turn on unless it is
connected to the REMOTE connector of the
camera recorder with included remote cable.
BS OUT connector
This is a connector that supplies the signal to
the base station.
Connect with the CA IN connector of the
base station using the BNC cable (5C-FW).
11
12
E-10