Panasonic AG-CA300G Instrucciones De Funcionamiento página 12

Part Names and Functions
6. BS IN connector
This is a connector receiving the signal from
the base station.
Connect with the CA OUT connector of the
base station using the BNC cable (5C-FW).
7. RET CTRL connector
This is a connector to be used when the
video signal output from the 2. VF OUT
connector is to be switched with the external
RET switch box. For the pin assignment,
refer to [About the RET CTRL connector]
(page 24).
8. RET signal selection switch
This is a switch that selects the video signal
output from the 2. VF OUT connector from
either the return signal (RET signal) from the
base station or the video signal recording on
the camera recorder.
It will switch to the return signal while the
switch is pushed.
<Note>
Video may be disrupted when the signal is
switched.
9. TALLY lamp
This will light up while the TALLY signal is
input to the unit from the base station.
It will also light up while the CALL switch on
the front panel of the base station is pressed.
However, there is no change when the CALL
switch on the base station is pressed while
this is lit with the TALLY signal input to the
unit.
10. CALL switch
TALLY lamp on the base station is lit while
this switch is pressed.
However, while the TALLY signal is input to
the base station, there will be no change
when the CALL switch is pressed on this
unit.
E-11
(continued)
11. BATTERY IN connector
This is a connector used to connect a battery
to the unit.
It is possible to operate the unit with a battery
by connecting the battery.
However, power supplied from the 1. DC IN
24 V connector will have priority if there is
power supplied from the 1. DC IN 24 V
connector.
When using a battery, mount the included
battery plate to the rear panel of this unit. For
the mounting method, refer to [Mounting of
the Battery Plate] (page 17).
12. DC IN 24 V connector cover
Mount this cover on the 1. DC IN 24 V
connector when the power supply cable is
not connected to the 1. DC IN 24 V
connector.