SOLIS Barista Perfecta Plus Manual Del Usuario página 18

Programming the appliance for use without water filter:
EN
The default setting is that no water filter is inserted. However, we recommend
●
inserting the included MAVEA Intenza water filter cartridge in any case and per-
forming the previously specified programming.
If for some reason you do not want to insert a water filter, you can leave the
●
default setting. If you have stopped using a water filter, proceed as described on
page 17, but push the
confirm the programming. The Prog. button flashes twice, the setting is saved
and completed and a signal sounds twice. The "no water filter" programming
disables the water filter replacement alarm and decreases the descaling interval
time.
ATTENTION: Do not run the machine without MAVEA Intenza water filter cartridge
with setting 'yes'. Any damage caused by limescale will not be covered by warranty.
In general:
Pushing the Prog. button gets you to programming mode.
Subsequently pushing the
After that, you can perform the following settings:
is the setting for "with water filter"
is the setting for "no water filter"
ATTENTION:
If the button alternately flashes white and red and simultaneously the
constantly lights up white, the water filter replacement alarm has been triggered!
In this case, empty out the water tank, replace the old water filter cartridge with a
new one and proceed as described on page 31!
18
button in the 4. step. Then, press the Prog. button to
button gets you to the water filter settings menu.
button