Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
3. From the 24-way harness:
Connect the Black wire to the ground wire of the aftermarket radio.
•
•
Connect the Yellow wire to the constant wire of the aftermarket radio.
•
If the vehicle is amplified disconnect the 4-pin harness located between
the 24-way and 22-way connector and connect the supplied 4-pin to 4-pin
resistor pad. If the vehicle is not amplified connect the two 4-pins for the
24 and 22-way together.
For amplified systems:
Note: Only make these connections if you do not have a digital amplifier.
Connect the Violet wire to the right rear positive wire of the
•
aftermarket radio.
•
Connect the Violet/Black wire to the right rear negative wire of the
aftermarket radio.
•
Connect the Green wire to the left rear positive wire of the
aftermarket radio.
Connect the Green/Black wire to the left rear negative wire of the
•
aftermarket radio.
AX-ADGM100
Connections to be made
4. From the 12-way harness:
12
For non-amplified systems:
•
Cut the resistors from the Green, Green/Black, Purple, Purple/Black
right below the heat shrink.
Connect the Violet wire to the right rear positive wire of the
•
aftermarket radio.
•
Connect the Violet/Black wire to the right rear negative wire of the
aftermarket radio.
•
Connect the Green wire to the left rear positive wire of the
aftermarket radio.
Connect the Green/Black wire to the left rear negative wire of the
•
aftermarket radio.
•
Connect the Blue/Pink wire to the aftermarket radios VSS (if populated on
factory side).
•
Connect the RCA to the AUX in on the aftermarket radio (if equipped) to
retain RSE and/or OE satellite radio.
Publicidad
Capítulos
Tabla de contenido
