Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Testing
•
Turn the ignition "on". Then turn the aftermarket radio "on".
•
Press the OnStar button, the radio should turn "off" (radio will mute if mute
wire is connected) and you should hear OnStar.
•
Push the OnStar cancel button and the radio should come back "on".
OnStar Level Adjustment
•
To adjust the OnStar volume level find the Black/Yellow wire on
the 16-pin harness.
•
Push the blue OnStar button, while the voice is speaking tap the
Black/Yellow wire to ground.
•
Once the volume is set it will stay at that volume until the Black/Yellow
wire is tapped to the ground again.
This can be set during installation and then left alone. If adjustment is
desired, the user may also tap "Volume Up" or "Down" on the steering
wheel (if equipped) to adjust the OnStar level.
AX-ADGM100
Section 4
Chime Volume Adjustment
1)
With car on, shut off car and leave keys in ignition. Open the car door and
leave it open. Chimes will be heard.
2)
Wait 10 seconds, then with a small screwdriver adjust the potentiometer
fully counterclockwise (all the-way left), then clockwise to raise chime level
and counterclockwise to lower the chime level.
3)
When the volume is at the desired level, remove the keys from the ignition.
This will lock the chime volume at its current level.
Audio Volume Adjustment
1)
Start your vehicle and turn on the radio having audio playing.
2)
Turn your aftermarket radio's volume up ¾ of the-way.
3)
With a small screwdriver adjust the potentiometer clockwise to raise the
audio level and counterclockwise to lower the audio level.
4)
Once at desired level your audio adjustment is complete.
14
Publicidad
Capítulos
Tabla de contenido
