Ps2_Usb_Pwr1 Jumper - ASROCK AD510PV Manual Del Usuario

2.5 Jumpers Setup 2.5 Jumpers Setup 2.5 Jumpers Setup
2.5 Jumpers Setup 2.5 Jumpers Setup
The illustration shows how jumpers are
setup. When the jumper cap is placed on
pins, the jumper is "Short". If no jumper cap
is placed on pins, the jumper is "Open". The
illustration shows a 3-pin jumper whose pin1
and pin2 are "Short" when jumper cap is
placed on these 2 pins.
Jumper
PS2_USB_PWR1
(see p.2 No. 1)
Note: To select +5VSB, it requires 2 Amp and higher standby current provided by
power supply.
1 2 1 2 1 2
1 2 1 2
ASRock AD510PV / AD410PV Motherboard
Short
Setting
Short pin2, pin3 to enable
+5VSB (standby) for PS/2
or USB wake up events.
Open
Description