Stagnoli HERCULES Instrucciones De Montaje página 10

Istruzioni Instructions Anleitungen Instrucciones Инструкция , Instrukcja
Installing the gear motor
Unscrew the two side screws to remove the top (Fig.4).
Position Hercules on the foundation plate, taking care
to centre the antiskid device (Fig.5).
Fix the gear motor to the foundation plate with the
screws but before tightening them completely, adjust
the distance between Hercules and the gate.
Take the first sector of the rack and position it on top of
the gear, check there is a clearance of at least 1 mm
between the gear and rack; fix it to the gate with the
screws.
Check the correct position by moving the gate by
hand (Fig.6).
Fig.4
1mm
Fig.5
Fig.6
Fix the rest of the rack, utilising a piece
of rack to maintain the pitch between
joints (Fig.7).
Position the limit switch brackets on
the rack and, sliding the gate, adjust
the position of the brackets according
to the opening and closing wanted.
Now fix the brackets permanently.
Fig.7
10