Device Management - Korenix JetNet 6710G-HVDC Serie Guía De Instalación Rápida

Following Figure 2.2-3 shows the color code of Cat.-5E UTP/STP cable based on the
two standards released by TIA/EIA – 568A and 568B. The 568B wiring is by far, the
most common wiring method. You can choose the method that suits your application;
but ensure that both ends of the cable use the same standard.

3. Device Management

JetNet 6710G series switches provide both in-band and out-band configuration methods. You
can configure the switch via the RS232 console with the attached console cable, or you can
remotely manage the switch via network using Telnet/SSH, Web/HTTPS management.
3.1 Preparation for console management
Attach the RS-232 DB9 connector to your PC's COM port. Connect the M12 A-code 5-pin
connector to the console port of the JetNet 6710G.
3.1.1 Go to Start -> Program -> Accessories -> Communication -> Hyper Terminal
3.1.2 Give a name to the new console connection to create a new serial communication
3.1.3 Choose the COM name, and select the correct serial settings. The serial settings of
JetNet 6710G are as below:
Baud Rate: 9600 / Parity check: None / Data Bit: 8 / Stop Bit: 1
3.1.4 After connected, you can see Switch login request. Type-in the username and
password to login. The default username is "admin", password is "admin" for console
interface.
3.1.5 Follow the manual to configure the device features.
Figure 2.2-3 RJ45 Cable color code