Foam Strip And Soundproofing Seal; Safety Instructions; Building In Under A Hob; Dishwasher With Built-In Hob - Brandt AX545FXE1 Instalación Y Consejos

Installing your dishwasher

Foam strip and soundproofing seal

To provide better noise insulation on
built-in appliances, install
soundproofing seals and the foam strip
supplied with your machine
(depending on the model).

Safety instructions

For your safety's sake, never leave your dishwasher's door fully open
after use.
If the machine is operating incorrectly, disconnect it from the
electricity supply (remove the plug) or switch off the circuit involved and
close the water supply tap. Contact our After-Sales department.
If your dishwasher is being installed on a carpeted floor, make
sure to adjust the feet to leave a ventilation space under the machine

Building in under a hob

If your worktop is fitted with a built-in hob over your dishwasher,
you must provide thermal insulation on top of the machine. You can
obtain this insulation kit from your dealer. Take care to leave a space
between the gas pipe and the top of your machine.
24
Installation of the adjustable
plinth on built-in appliances
the (depending
on the model)
DISPONIBLE EN
R
SOUS ÉF
GB
Installing your dishwasher

Dishwasher with built-in hob

To avoid hindering manipulation of the cooking utensils, we
would recommend that you install the dishwasher so that there
are no units or walls at least 30cm to the right and left of the hob. This
S.A.V.
distance can be reduced but must not be less than 4cm between the edge of
. : 32X0050
the hob and any unit or wall rising above the height of the worktop to the
right or left of the dishwasher to avoid any risk of damage.
Your dishwasher combines 2 functions, which means that it
must be connected to the wall so that it is completely safe to
use. This is to prevent a child, who may accidentally lean on the door while
you are loading or unloading the dishes, from causing a hot (boiling) pan
resting on the hob to fall, resulting in severe burns or scalds. A set of
instructions and an anti-tilt device are supplied with this machine.
It is essential that these instructions be observed.
Unless the anti-tilt
device is installed correctly, the
machine will not operate. See
the notice stuck onto the
machine.
Putting a facing on the
door: please refer to Page 20
Fixing installed = safety
GB
25