Troy-Bilt LS 33 TB Manual Del Operador página 10

NOTE: Approved fluids include Shell Tellus® S2 M
32 Hydraulic Fluid, Dexron® III/Mercon® automatic
transmission fluid, Pro-Select™ AW-32 Hydraulic Oil or
10WAW-ISO viscosity grade 32 hydraulic oil. It is not
recommended that fluids be mixed, to top off the reservoir
tank during initial set-up use Shell Tellus® S2 M 32 Hydraulic
Fluid only.
4. Replace the vented dipstick securely, tightening it until the
top of the threads are flush with top of the pipe.
5. Disconnect the spark plug and prime the pump by pulling the
recoil starter as far as it will go. Repeat approximately 10 times.
6. Reconnect the spark plug wire and start the engine
following instructions in the Engine Operator's manual.
7. Use the control handle to engage the wedge to the farthest
extended position. Then retract the wedge.
8. Refill the tank as specified on the dipstick if necessary
NOTE: Failure to refill the tank will void the splitter's
warranty.
9. Extend and retract the wedge 12 complete cycles to
remove any trapped air in the system (the system is "self-
bleeding").
10. Refill the reservoir within the range marked on the dipstick
if necessary.
NOTE: Some fluid may overflow from the vent plug as
the system builds heat and the fluid expands and seeks a
balanced level.
Tire Pressure
The max recommended operating pressure is 30 psi. Do
not under any circumstances exceed the manufacturer's
recommended psi. Maintain equal pressure in both tires.
WARNING!
may cause tire/rim assembly to burst with force
sufficient to cause serious injury.
10 S 3— A
ection SSembly
Excessive pressure when seating beads
& S -U
et p