Haier HSU-07HV03/R2 Manual De Instrucciones página 21

Operation
Heat Operation
Remote controller
TEMP
HEALTH FAN
SWING
MODE H AIR
SLEEP FRESH
CLOCK SET
TIMER
LOCK LIGHT CODE RESET
1. Unit start
Press on/off button ("
2.Select operation mode
Press MODE button. For each press, operation mode
changes as follows:
Remote controller:
AUTO
Then Select HEAT operation
On the displaying board,colorful displaying bar will be red
3.Select temp.setting
Press TEMP. button
Every time the button is pressed, temp.setting
o
increase 1 C,if kept depressed, it will increase
rapidly
Every time the button is pressed, temp.setting
o
decrease 1 C,if kept depressed, it will decrease
rapidly
Select a desired temperature.
4.Fan speed selection
Press FAN button. For each press, fan speed changes as
follows:
Remote controller:
LOW
Air conditioner is running under displayed fan speed
IN HEAT mode, warm air will blow out after a short period
of the time due to cold-draft prevention function.
When FAN is set to AUTO, the air conditioner
automatically adjusts the fan speed according to room
temperature.
5.Unit stop
Press on/off button (" "), the unit stops.
14
") on the remote controller, unit starts.
COOL DRY FAN
HI AUTO
MED
HEAT