Remote Control Buttons - cinetto B-Moved PS40.3 Manual Del Usario

WARNINGS AND USE INSTRUCTIONS
1. System use guidelines
1.1 General description of the 'B-Moved' system
'B-Moved' is an electronically-controlled mechanical system for moving cabinet or similar doors on the special sliding
arrangements indicated in the instructions. Each door is equipped with a movement bar, composed of a screw axially
connected to an electric motor, which drives a lead nut attached to the door.
Unless otherwise indicated, the mass limit of each of the doors to be moved is indicated in the technical specifi cations of
the Cinetto sliding system with which it is combined.
The system can be activated by a slight push of the door or by the remote control supplied.
1.2 Installation features: program self-learning
The system is able to simultaneously manage up to 4 doors each combined with a movement bar.
The electronic control unit can be combined with movement bars numbered between 1 and 4. In addition to connected doors, the
system also manages various operating modes and programs to match the exact sliding system used.
'B-Moved' identifi es the program to be used based on how the movement bars are connected to the control unit, and each move-
ment system is supplied with specifi c instructions for connecting the movement bars.
1.3 Installation features: door track self-learning
The system is equipped with a specifi c function for setting door track limits. After the system is installed, this function can be acti-
vated by pressing the 'SET/RESET' button on the control unit for 3 seconds. Before activating this function, ensure that the supplied
mechanical track limit stops are positioned according to instructions and that the doors start in the closed position.
This function can be activated at any time and previously memorized track limits will be overwritten.
1.4 Installation features: remote control pairing
This function allows the pairing of the supplied remote control with the desired control unit. The remote control pairing codes are
stored in the receiver.
Multiple control units can be paired and used with a single remote control.
Multiple remote controls can be paired and used with the same control unit.
1.5 Movement control

1.6 Remote control buttons

To guarantee the compatibility of the remote control with all cabinet confi gurations, every remote control has 4 buttons. The active
70
Following track setting and remote control pa-
ring, the system is operational.
The movement of each door can then be control-
led by a slight push in the opening direction or
by using the remote control.
Manual and remote controls are totally compa-
tible with each other. The door will move in the
desired direction and then remain stopped until
the next control command.