Tips For Saving Energy - Svan SVF1885NFDX Manual De Instrucciones

IMPORTANT NOTES:
• Compressor protection function will be activated after sudden power breakdowns or after
unplugging the appliance, because the gas in the cooling system is not stabilized yet.
Your fridge will start after 5 minutes, there is nothing to worry about.
• If you will not use your fridge for a long time (e.g. in summer holidays) unplug it. Clean
your fridge according to Part 4 and leave the door open to prevent humidity and smell.
• If the problem persists after you have followed all the instructions above, please consult
to the nearest authorized service.
• The appliance you bought is designed for home type use and can be used only at home
and for the stated purposes. It is not suitable for commercial or common use. If the
consumer use the appliance in a way that does not comply with these features, we
emphasize that the producer and the dealer shall not be responsible for any repair and
failure within the guarantee period.

Tips for saving energy

1– Install the appliance in a cool, well ventilated room, but not in direct sunlight and not near
heat sources (radiator, cooker.. etc. ). If you install it near heat sources, use an insulating
plate.
2– Allow warm food and drinks to cool down before putting them in the refrigerator or freezer
compartment.
3– When thawing frozen food, place it in the refrigerator compartment. The low temperature of
the frozen food will help to cool the refrigerator compartment while it is thawing, reducing
the energy required.
4– When placing liquids in the appliance, make sure they are covered. Otherwise humidity
increases inside the appliance and the time taken to cool them is longer. Also covering
drinks and liquids helps preserve the smell and taste.
5– When placing food and drinks in the appliance, open and close the appliance door as
quickly as possible to keep the temperature inside the appliance stable.
6– Keep the covers closed of any compartments with different temperature requirements in
the appliance (crisper, chiller ...etc. ).
7– Make sure the door gasket is clean and pliable. Replace gaskets if they are worn or
damaged.
EN -78-