Johnson Pump SPXFLOW 500 GPH Manual De Instrucciones página 8

> English
Threaded Discharge Installa-
tion Instructions:
Unassembled Fittings
1. Install the appropriate barb
fitting straight or 90° into the ¾"
connector nut. Place the sealing
washer into the connector nut
afterwards.
2. Install the hose clamp loosely on
the discharge hose and install
the hose onto the barb. Tighten
the hose clamp securely.
3. Thread the assembled connector
nut onto the pump discharge
port, position the hose and
tighten the connector nut.
Tighten the assembly ¼ turn
past hand tightness.
Pre-assembled fittings
1. Install the hose clamp loosely on
the discharge hose. Install the
hose onto the barb fitting and
position as necessary. Tighten
the hose clamp securely.
2. Check the tightness of the
connector nut.
Threaded nuts do not require
mechanical tightening. Do
not over tighten, damage may
occur.
Marine type sealants are not requi-
red, periodic check for tightness is
recommended.
8
Original instructions