Troubleshooting - Luminance Brands Kathy Ireland Home LINDBERGH ECO CF315BS00 El Manual Del Propietario

FOR YOUR OWN SAFETY TURN OFF POWER AT FUSE BOX OR CIRCUIT BREAKER BEFORE
TROUBLESHOOTING YOUR FAN.
TROUBLE
TROUBLE
1. Fan will not start. 1 . Fuse or circuit breaker blown .
2 . Loose power line connections to the fan .
3 . Fan/Light wall control is OFF .
4 . Wall control is not programmed .
2. Fan sounds
1 . Blades not attached to fan .
noisy.
2 . Screws securing fan motor to motor
hub are loose .
3 . Screws holding blades to motor are loose .
4 . The shade is loose .
5 . Hanger bracket and/or ceiling outlet box is
not securely fastened .
3. Fan wobbles
1 . Screws securing fan blades to motor are
excessively.
loose .
2 . Set screw in motor coupler is loose .
3 . Fan blades out of balance .
4 . Hanger bracket and/or ceiling outlet box is
not securely fastened .
5 . Set screw in hanger ball/downrod assembly
is loose .
6 . Screws securing fan motor to the motor hub
are loose .
4. Light fixture will 1 . Loose electrical connectors .
not illuminate.

15. Troubleshooting

WARNING
!
PROBABLE CAUSE
PROBABLE CAUSE
SUGGESTED REMEDY
SUGGESTED REMEDY
1 . Check main and branch circuit fuses or circuit breakers .
Make sure main power is turned OFF.
2 . Check line power connections to fan .
3 . Turn ON fan/light wall control .
4 . Program the wall control and receiver per the Owner's
Manual instructions .
1 . Attach blades to fan before operating .
Make sure main power is turned OFF.
2 . Check to make sure the screws which attach the blades
to the motor are tight .
3 . Tighten screws securely .
4 . Tighten the shade securely .
5 . Tighten the hanger bracket screws to the outlet box,
and/or secure outlet box .
1 . Check to be sure screws which attach the fan blade to
the motor are tight .
2 . Raise coupler cover and tighten the set screw securely .
3 . Interchanging an adjacent (side by-side) blade pair can
redistribute the weight and result in smoother operation .
Or use supplied balancing kit to balance blades .
4 . Tighten the hanger bracket screws to the outlet box,
and/or secure outlet box .
5 . Tighten the set screw in the hanger ball/downrod
assembly .
6 . Check to be sure the screws which attach the
motor to the motor hub are tight .
1 . Shut off the branch circuit electricity at the fuse box or
breaker panel and check the electrical connectors for
proper installation .
30
WARNING
!
WARNING
!
ETL Model No.: CF315