Luminance Brands Kathy Ireland Home LINDBERGH ECO CF315BS00 El Manual Del Propietario página 6

3. Ceiling Fan Assembly
3.2
Remove One of the Three #6-32 x 3/8" Pan Head
Screws with Lockwashers from the Fan Motor Hub
(Figure 2) .
Retain the #6-32 x 3/8" Pan Head Screw with
Lockwasher for future use .
Loosen the Two #6-32 x 3/8" Pan Head Screws with
Lockwashers (Figure 2) .
3.3
Place the 2-pin Fan Motor Assembly connector through
the large center hole of the Light Kit Adapter (Figure 3) .
Position the Light Kit Adapter Key Hole Slots onto the
Two loosened Screw Heads .
Rotate the Light Kit Adapter Clockwise to engage the
Two Screws .
NOTE: Verify that the serrated washers are not
trapped between the Light Kit Adapter and the Fan
Motor Hub.
Reinstall the previously removed #6-32 x 3/8" Pan Head
Screw with Lockwasher (Figure 3) .
Retighten all Three #6-32 x 3/8" Pan Head Screws with
Lockwashers to securely attach the Light Kit Adapter to
the Fan Motor Hub (Figure 3) .
A spare #6-32 x 3/8" Pan Head Screw with Lockwasher
is in the hardware bag, if needed .
Carefully turn the partially assembled Ceiling Fan
right side up and position the Fan on the styrofoam in
preparation for additional assembly .
3.4
Remove the Hanger Ball by loosening the Phillips Head
Set Screw in the Hanger Ball until the Ball falls freely
down the 6" Downrod (Figure 4) .
Remove the Pin from the 6" Downrod, then remove the
Hanger Ball (Figure 4) .
Retain the Pin and Hanger Ball for reinstallation in
Step 3 .11 .
NOTE: Do not loosen the screw that attaches the
green ground wire to the hanger ball.
(Continued)
Figure 2
LIGHT KIT
ADAPTER
Figure 3
PIN
PHILLIPS HEAD SET SCREW
Figure 4 (LOOSENED)
6
REMOVE AND RETAIN
ONE #6-32 x 3/8" PAN
HEAD SCREW
w/LOCKWASHER
LOOSEN TWO #6-32 x 3/8"
PAN HEAD SCREWS
w/LOCKWASHERS
REINSTALL & TIGHTEN
THE #6-32 x 3/8" PAN
HEAD SCREW
w/LOCKWASHER
RETIGHTEN THE #6-32 x 3/8"
PAN HEAD SCREWS
w/LOCKWASHERS (2)
GREEN GROUND WIRE
6" DOWNROD
HANGER BALL
ETL Model No.: CF315