Post-Use Maintenance; Preparation For Maintenance; Cleaning And Disinfection - NSK Surgic Pro2 Manual Del Usuario

Post-use Maintenance

6
6 – 1 Preparation for maintenance
1 Wear eye protection, a mask, and gloves to prevent
infection�
2 Turn off the power switch of the control unit�
● Failure to properly maintain the products may cause infection, product failure, or overheating and injuries:
– Be sure to clean and disinfect the products immediately (within 1 hour) after use to remove residue�
● Do not clean, immerse, or wipe with electrolyzed-oxidizing water (strong acidic water, super acidic water), strong
acidic and strong alkaline liquid solution, solvent containing chlorine, benzene or thinner�
● Follow any additional local directives, standards, and guidelines for cleaning, disinfection and sterilization�
● For maintenance of the handpiece, internal spray nozzle, nozzle holder and cleaning wire, refer to the handpiece
operation manual�
6 – 2 Cleaning and disinfection
Manual Method
For the motor with motor cord and handpiece stand
_ Cleaning
1 Remove the tube holder (gray) from the motor with
motor cord� For cleaning and disinfection of the tube
holder (gray), see "For the tube holders, tube holder
(gray), calibration bur and protection plug"�
2 Attach the protection plug to the motor with motor
cord�
3 Remove the bur/drill from the handpiece�
4 Remove the handpiece from the motor�
5 Remove the motor cord from the control unit�
WARNING
CAUTION
3 Clean the surface of the products under running
water with a soft bristled brush under the following
conditions�
Time: 1 minute for the motor with motor cord, 15
seconds for the handpiece stand
Water temperature: ≤38 °C
Water quality: Drinking water
Water flow rate: ≥3�5 L/min
4 Remove any remaining moisture from the product
using a dry cloth or filtered clean and dry
compressed air (≤0�35 MPa) ensuring it is dry
internally and externally�
5 Remove the protection plug from the motor with
motor cord� Under appropriate lighting (≥500 lx),
inspect the products for contamination�
If any visible contamination remains, attach the
protection plug to the motor with the motor cord
again and repeat the process until it is visually clean
following step 3�
26