Electrical Connection; Assembly - Ferroli NAPOLI Instrucciones Para La Instalación

N A P O L I
Under no circumstances may the thermal emitter be installed under an electrical outlet.
Choose the location of the thermal emitter following the minimum distances indicated below:
Note: If the window sill protrudes less than 20 mm, the space above the emitter may be ignored.

3. ELECTRICAL CONNECTION

The thermal emitter must be connected to the power line (230 V ~ 50 Hz) via its plug. The following
warnings must also be taken into account:
- The device must not be placed below an electrical outlet or switch.
- The power line must be protected with a high-sensitivity differential device.

4. ASSEMBLY

The thermal emitter must be held by its handles, as shown in the following image:
A73023140
47
EN