Tools Needed; Hardware Provided - Koala Kare KB208 Instrucciones De Instalación Y Funcionamiento

OPERATING INSTRUCTIONS
Please Note:
To assure proper installation, it is suggested that a qualified person or carpenter install the Koala
Kare Baby Changing Station. Koala Kare Products will not be responsible if the station is not
installed properly.
Koala Kare Baby Changing Stations have been tested to hold a substantial static load. The
unit must be attached to a permanent wall that is capable of holding a substantial load. The
maximum recommended total weight for this baby changing station (including baby and parcel
bag) is 60 lbs. Excessive weight may cause a hazardous or unstable condition to exist.
Restraint System: To fasten the waist restraint strap, place strap around child's midsection, and
push spring tabs into buckle until both spring tabs lock in place with an audible "click". Straps
can be adjusted to make strap tighter or looser as required.
Inspection Criteria:
A properly maintained Baby Changing Station:
- Opens and closes smoothly.
- Has both ends of a functioning, non-frayed strap: buckle clicks when closed and strap is
attached at both ends of unit.
- Provides a clean, convenient place for customers to attend to their children.
Measuring
Tape
Gloves
Drill
Four 1/4"x 3" Phillips
Panhead Wood Screws
1

TOOLS NEEDED

Phillips Head
Screwdriver
1/8" Drill Bit
(regular)

HARDWARE PROVIDED

Four
¾" x ¼"
Level
7/32" Drill Bit
(masonry)
Flat Washers Two
Screw Hole Plugs
Stud
Finder
Pencil
1/2" Drill Bit
(masonry)