Starting The Engine; Stopping The Engine - Lea LE36260-60DR Instrucciones Originales

Clean around the screw plug and the tank after refuelling.
Always wipe up any spilt fuel to prevent a fire.
7.3 Storage of fuel
Fuel cannot be stored for an unlimited period of time.
Purchase only the quantity required for a 4-week operating period.
Use approved fuel storage containers only.
8. OPERATION

8.1 Starting the engine

Move at least 3 metres away from the place of refuelling. Place the hedge trimmer on a clean
area of ground and make sure that the cutting tool does not come into contact with the ground
or any other objects.
Keep the blades clear of everything around, since they will start moving as soon as
the engine starts.
Cold starting
If the engine is cold or if it has been stopped for more than 5 minutes or if fuel has been added
to the engine.
1) Push the switch (11) to the "I" position.(Fig.3)
2) Push the primer pump gently (7 to 10 times) until fuel begins to flow into it.(Fig.4)
3) Move the choke lever (4) to position
4) Hold the unit down firmly so that you will not lose control while cranking the engine. If not
held down properly, the engine could make you lose your balance or swing the cutting blade
into a nearby object or your body.
5) Pull out the starter handle slowly (10 to 15 cm), and check the pressure. Pull strongly when
you feel the pressure and start the engine.
6) When the engine starts, return the choke lever to
return to position automatically when the throttle lever is moved and the throttle is opened.
7) Run the engine for approximately one minute at a moderate speed before moving up to full
speed.
Note: When restarting the engine immediately after stopping it, leave the choke
open.
Note: Overchoking can make it hard to start the engine due to excess fuel. If the
engine fails to start after several attempts, open the choke and pull the rope again, or
remove the sparking plug and dry it.
Hot starting
Restarting immediately after the engine has stopped. When restarting a hot engine, first try the
above procedure: 1,2,4,5,6. If the engine does not start, repeat the above steps
Do not pull the rope to the end or return it by releasing the knob. This can cause
starter failures.

8.2 Stopping the engine

(Fig.5)
Please note that the choke lever will
19