PR electronics 9410 Manual Del Producto página 17

LERBAKKEN 10, 8410 RØNDE DENMARK
Installation notes:
General
The 9410 must be supplied from a Power Source with Double or Reinforced
insulation to Mains.
Terminal blocks :
Wire size
Screw terminal torque
For installation in Zone 2
The 9410 Power Control Unit and 9400 Power Rail must be installed in an outer
enclosure having an IP protection of at least IP54, conforming to the
requirements of explosion protection Ex-n or Ex-e.
Transients are suppressed by an internal transient protection device, which is
set to a level not exceding 40% of the rated voltage.
WARNING: Do not separate connectors when energized and an explosive gas
mixture is present.
WARNING: Do not install or remove modules from the Power Rail unless Area
is known to be Non Hazardous.
WARNING:Terminals 91,92,93,94,95 may only be connected to Power Rail
9400.
.
Revision date:
2012-06-27
0.13-2.08 mm² / AWG 26-14 stranded wire
0.5 Nm
Version Revision
V3R0
9410 - Versión del producto 9410-001
WWW.PRELECTRONICS.COM
Prepared by:
PB
9410QI01
Page:
3/3
17