Midland ENERJUMP Manual De Instrucciones página 18

All manuals and user guides at all-guides.com
turn on the engine.
Red led on and buzzing: incorrect connection. Remove the cable (circuit)
-
from Enerjump and try again. Then turn on the vehicle.
- Flashing green led and buzzing: the battery of your vehicle has a low vol-
tage. Push the "BOOST" key; the green led lights up. Turn on the engine
within 30 seconds.
- All leds are off and no buzzing: the battery of your vehicle is probably dead.
Make sure that the connection is correct and then press the "BOOST"
button: the green led lights up. Start the vehicle within 30 seconds.
6. If the engine starts, remove the jumper cable from Enerjump and disconnect
the red and black clamps from the vehicle's battery terminal within 30 seconds.
7. Leave the vehicle's engine running for a few minutes.
8. If the vehicle does not start on the fi rst trial, wait for 1 minute before trying to
start the vehicle again.
CHARGING A MOBILE DEVICE WITH USB PORT
Plug the USB cable to the USB 5V-2A output port .
Connect the other end of the cable to your device. The charging lights will be on
when charging.
BEEP, BEEP BEEP, BEEP
ENERJUMP - 13