Luminance Brands Kathy Ireland Home ZEKE CF444BQ00 El Manual Del Propietario página 9

3. Ceiling Fan Assembly
3.10
Place the Ceiling Cover over the 6" Downrod
(Figure 10) .
Be sure that the Ceiling Cover and the Coupler Cover
are both oriented correctly (Figure 10) .
3.11
Route the three Motor Wires through the Hanger Ball
(Figure 11) .
Reinstall the Hanger Ball on the 6" Downrod as follows:
Position the Pin through the Two Holes in the
6" Downrod and align the Hanger Ball so the Pin is
captured in the Groove in the top of the Hanger Ball
(Figure 11) .
Pull the Hanger Ball up tight against the Pin and
securely retighten the Phillips Head Set Screw in the
Hanger Ball (Figure 11) .
A loose Phillips Head Set Screw could create fan
wobble .
3.12
The Fan comes with Black, Blue and White Wires that
are 80-inches long .
Before installing the Fan, measure up approximately
6 to 9-inches above top of Hanger Ball/Downrod
Assembly (Figure 12) .
Cut off excess Wires and strip back insulation 1/2-inch
from end of Wires .
You have now partially completed the assembly of
your new Ceiling Fan, proceed to "How to Hang Your
Ceiling Fan" . Final Assembly of the Ceiling Fan will be
completed once Ceiling Fan is Hung and Wired .
(Continued)
6" DOWNROD
CEILING
COVER
Figure 10
PIN
HANGER BALL
6" DOWNROD
Figure 11
6 TO 9
INCHES
1/2
INCH
Figure 12
Please contact 1-800-777-4440 for further assistance
9
SET SCREW
BLACK WIRE
BLUE WIRE
WHITE WIRE
HANGER
BALL
luminancebrands.com
ETL Model No.: CF444