Troubleshooting - Stiga Villa 2WD Serie Uso Y Mantenimiento

EN
Problem
1 The starter motor does not
turn
2 The starter motor turns but
the engine doesn't start
With the ignition key in the
start position, the starter
motor turns but the engine
doesn't start
3. Difficulty in engine start-up
or engine runs irregularly
4 Drop in engine performance
during cutting
5 The engine stops for no
apparent reason
6 Uneven cutting
7 Abnormal vibration during
use
8 With the engine running,
activation of the traction pedal
does not move the machine
If any of the faults listed below occurs, replace the relevant fuse (20)
9 The engine does not start or
starts and stops immediately
The battery is charged
If problems persist after the operations above have been performed, contact your dealer.
Warning! Never attempt to carry out complicated repairs without the necessary tools or
technical ability Any poorly performed interventions will automatically nullify the warranty
and exonerate the manufacturer from all liability
24
ENGLISH

14 TROUBLESHOOTING

Probable cause
Battery not charged enough.
Battery not connected.
Fuse 20A blown.
Fuel cock closed.
No fuel flow.
Ignition fault.
Carburettor problems.
Forward speed too high in rela-
tion to the cutting height.
- Fuel tank empty.
- Try to restart the engine.
The cutting device sharpness
level is low.
Forward speed too high in
relation to the height of the grass
being cut.
The cutting device assy is full of
grass.
- Unbalanced cutting devices.
- Slackened cutting devices.
- loose components.
- possible damage.
"Disengage transmission" lever in
the disengaged position.
Fuse 20A blown.
(Translation of the Original Instructions)
Remedy
Recharge the flat battery.
Check the connections.
Replace the fuse
Open the fuel cock.
- Check the fuel level in the tank.
- Check the fuel filter.
- Check the spark plug cap is
securely in place.
- Check the spark gap and that
the electrodes are clean.
Clean or replace the air filter.
Reduce the forward speed and/
or raise the cutting height.
Fill the fuel tank (if the problem
persists, contact an authorised
assistance centre).
Check the tyre pressure.
Contact an authorised assistan-
ce centre.
Reduce the forward speed and/
or raise the cutting height.
- Wait for the grass to dry.
- Clean the cutting device assy.
Contact an authorised assistan-
ce centre for inspection, replace-
ment or repair operations.
Engage the transmission.
Replace fuse 20A.