Kohler Sterling NI3100 Serie Manual Del Usuario página 14

Wall Jamb
Pencil
9. Drill Mounting Holes
Position one wall jamb over the end of the bottom "C" frame. The wall jamb slots should be facing
the inside of the shower.
Align the outside edge of the wall jamb with the mark made on the bottom "C" frame.
NOTE: The wall jamb must sit flat on the shower ledge. If the ledge has a curve in the corners at the side
wall, it may be necessary to shape the bottom end of the wall jamb with a file.
Using a level, plumb the wall jamb.
Mark the three wall mounting holes with a pencil.
NOTICE: For ceramic tile walls, use a center punch to lightly punch the three hole locations for the wall
jamb before drilling. This will prevent the ceramic tile from cracking.
Slowly drill a 5/16" hole at the marked hole locations.
Thoroughly clean the ledge and wall of debris.
Press and hold the legs of each wall anchor (provided) together and insert the wall anchor legs into
the pre-drilled mounting holes.
Repeat for all the wall anchors.
Repeat the above procedure for the remaining wall jamb.
1034047-2-G
Level
Pencil
Bottom "C" Frame
Level
Press and hold legs together.
Wall Jamb
14
Anchor
Sterling