Preface; Hazard Notices; Description; Technical Data - Nederman 1355 Manual De Instrucciones

EN Welding and Grinding Table
1

Preface

Read this manual carefully before installation, use and service of this product. Replace
the manual immediately if lost. Nederman reserves the right, without previous notice, to
modify and improve its products including documentation.
All installation, maintenance and repair is to be done by qualified personnel using
only Nederman original spare parts. Contact the nearest authorized distributor or
Nederman for advice on technical service. If there are any damaged or missing parts
when the product is delivered, notify the carrier and the local Nederman representative
immediately.
2

Hazard notices

This document contains important information that is presented either as a warning,
caution or note. See the following examples:
WARNING!
Warnings indicate a potential hazard to the health and safety of personnel, and how
that hazard may be avoided.
CAUTION! Type of risk.
Cautions indicate a potential hazard to the product but not to personnel, and how that
hazard may be avoided.
NOTE!
Notes contain other information that is important for personnel.
3

Description

3.1

Technical data

Table 3-1: Technical data
Welding / grinding table
Welding / grinding table
Welding / grinding table
Dimensions
Material description
Weight
Dust drawer volume
Recovery level
Max. distributed load on the table:
4

Installation

NOTE!
For storing the welding gun, see figure 2 and the following list.
1. Welding ground clamp.
2. Earth cable.
3. Holder for welding pistol.
The Welding and Grinding Table should be located with consideration for easy handling
of the collected dust and for convenience of service and maintenance, see Figure 3.
The table is usually installed on a reinforced concrete foundation. When calculating for
foundation or supporting structure it should be taken into consideration the total weight
8
Type of injury.
W1 (mm) W2 (mm)
900 1000
1355 1455
2000 2100
See figure 1
2 mm powder coated steel, colour code: RAL 9005
175, 260 or 360 kg
45, 68 or 100 litre
100 % of weight
500 kg
∅1 (mm)
c/c (mm)
160 970
250 1425
2 x 250 2075
c/c 990
Airflow (m3/h)
1000 - 2000
2000 - 3000
3000 - 4000