Leak Tests - IKEA GRILLSKÄR Manual Del Usuario

Always follow care and maintenance instructions
– regularly maintain your side burner.
Do not allow grease, fat or food residue to build
up in or on the side burner – RISK OF FIRE.
Always replace worn parts
Do not use the appliance if it has damaged or
worn seals.
Do not use an appliance which is leaking,
damaged or which does not operate properly.
Do not store or cover the side burner until fully
cooled.
Keep the ventilation opening of the cylinder
enclosure free and clear from debris.
Keep the area around your gas side burner clear
of any combustible materials, petrol or other
flammable liquids and vapours.
Pressure regulator and assembly supplied with
this barbecue/side burner must be used.
Replacement pressure regulators must be the
same as those supplied originally with the side
burner.
Never use an adjustable regulator with this side
burner.
Do not hang any combustible materials from the
hand rails of this barbecue/side burner.
Accessible parts may be very hot. Keep young
children away.
Always wear protective gloves or a barbecue mitt
when handling hot components or items such as
pots.
A cooking vessel with a diameter of no less than
10cm (3.9") and no greater than 26cm (10") should
only be used.

LEAK TESTS

IMPORTANT – PERFORM LEAK TESTS BEFORE USE
Always leak test the unit – annually, when dismantled,
when parts are replaced, or if the gas cylinder is
removed or replaced.
• Never use an open flame to check for leaks at
anytime. DO NOT IGNITE THE SIDE BURNER
DURING LEAK TESTING.
• To be performed in a well-ventilated area.
• Be sure all control knobs are in the 'OFF' position.
• Check for leaks by brushing a solution of 1/2
water and 1/2 soap over all the gas system joints,
including all valve connections, hose connections
and regulator connections.
• Ensure the soap solution has been applied to
all connections – connect the regulator to the
gas cylinder, open the gas control valve on the
regulator allowing gas to flow.
• OBSERVE – if bubbles form over any part of the
joints there is a leak.
• Turn off the gas and tighten all joints
• Repeat test. If bubbles form again, do not use the
side burner. Please contact your local dealer for
assistance.
GAS AND REGULATOR INSTRUCTIONS
• The cylinder should be positioned underneath the
main barbecue body and stored upright.
• Gas cylinders should never be stored or laid on
their side.
User instructions
GRILLSKÄR side burner is only to be used together
with GRILLSKÄR gas barbecue. Before assembling your
side burner, remove all protective packaging from
each part. Do not store a spare LP gas cylinder under
or near this appliance. Cylinder used must include a
collar to protect the cylinder valve.
Place dust cap on cylinder valve outlet whenever the
cylinder is not in use. Only install the type of dust cap
on the cylinder valve outlet that is provided with the
cylinder valve. Other types of caps or plugs may result
in leakage of propane.
SIDE BURNER USER INSTRUCTIONS
Before proceeding, make certain that you understand
the warning statements in this manual.
Lighting the side burner
• Open the side burner lid.
• Ensure the control knob is in the "OFF" position.
OFF HI LO
OFF
• Turn on the gas supply at the gas cylinder.
• Push control knob down and turn to ignition
position.
HI
• Hold control knob in for at least 10 seconds to
ensure the burner stays lit.
• If burner does not light after holding dial in for
20 seconds, turn the control knob to the 'OFF'
position and wait for 1 minute and try again. Do
not continuously hold the control knob in as you
may cause a build up of gas.
• In windy conditions shield from wind to ensure
easy lighting.
• Turn control knob to alter burner settings as
required.
23