5/ Use; Checking The Water Parameters - Pool Technologie Nano pH Manual Del Usuario

On the startup of the device, the pH regulation takes 60 seconds to start.
On entering the menus, the regulation is stopped. It restarts on exiting the menus, after a delay of 10 seconds.
ADJUSTING THE pH SETTING
2
The setting adjustment menu is accessed via the button
The adjustment range is between pH 6.8 and pH 7.6.
The first time it is switched on, the device is factory programmed with a setting of 7.2.
1/ Press the button
current setting as a flashing value.
2/ Adjust it to the desired setting with the buttons
3/ To confirm, press the button for 3 seconds
4/ To exit the menu and return to the pH value display, press the button
30 seconds.
5/ The display returns to the main screen showing the pH value.
Maintenance tips:
Never use hydrochloric acid. Only use pH corrector products recommended by your professional dealer. The use of any
other chemicals can cause irreversible damage to the device.

5/ USE

1

CHECKING THE WATER PARAMETERS

In the initial installation of the device or at the start of every new season, always check and correct the
following:
The water condition
pH
TAS / HT
Beware of water from wells!
Water from the mains water supply should preferably be used. Avoid water from natural sources (rain, runoff,
lakes or wells).
NANO pH – PAPI004092MULTI – FR/EN/DE/ESP/IT/PT – Rev.04.15
for 3 seconds and access the setting adjustment menu. The display shows the
Clear, without algae or sediment
Stabilised between 7.0 and 7.4
Important: Whatever chemical treatment system is used, the effectiveness of chlorine
decreases very rapidly with increasing pH, and tartar is deposited more quickly when the pH is
high or unstable.
The water should be correctly balanced (TAS, HT):
 The Total Alkali Strength (TAS) indicates the level of dissolved
bicarbonates in the water.
 The Total Hardness (TH) indicates the hardness of the water, i.e. the
content of calcium and magnesium salts dissolved in the water.
Your device is now up and running.
.
and .
. The selected value stops flashing.
for 3 seconds or simply wait
6