IKA EUROSTAR 60 control Manual Del Usuario página 13

EUROSTAR 100 control:
The direction of rotation of the EUROSTAR 100 control stirrer
can be changed by pressing the "Rev" button (K) when the stirrer
is in stand-by status (stationary).
EUROSTAR 200, 200 P4 and 400 control:
• Speed setting:
You can use the rotary knob (B, see Fig. 1) to pre-set the required
speed before you start the device. If you then press the rotary
knob(B, see Fig. 1) the device starts at the speed you set. When
a change is made to the speed, the rated speed is shown in the
display (C, see Fig. 1). When the device is stopped, the button (K,
see Fig. 1) can be used to switch between the two speed ranges
(I and II). When in standby mode, the display (C, see Fig. 1) shows
the set speed.
The stirrer has two different speed ranges:
Range I: low speed, high torque.
Range II: high speed, low torque.
• Correct procedure for changing the speed range:
- Switch the device off at the rotary knob (B, see Fig. 1).
- Switch the speed range with button (K, see Fig. 1).
- Change the speed with the rotary knob (B, see Fig. 1).
- Switch the device on at the rotary knob (B, see Fig. 1).
- The speed can be varied at any time in operation.
- The speed appears in the display (C, see Fig. 1).
13