Unpacking Instructions - Fanimation KLOUT FP3070 Serie Manual De Instrucciones

Ocultar thumbs

Tabla de contenido

Idiomas disponibles

This manual is designed to make it as easy as possible for you to assemble,

Tools Needed for Assembly

(Not Included)

• One Phillips head screwdriver

• One ¼˝ blade screwdriver

WARNING

Before assembling your ceiling fan, refer to section on

proper method of wiring your fan (page 10). If you feel you

do not have enough wiring knowledge or experience, have

your fan installed by a licensed electrician.

For your convenience, check-off each step. As each step is completed, place a check mark. This will ensure that all steps have been

completed and will be helpful in finding your place should you be interrupted.

Do not install or use fan if any part is damaged or missing. This product is designed to use only those parts supplied with

this product and/or any accessories designated specifically for use with this product by Fanimation. Substitution of parts

or accessories not designated for use with this product by Fanimation could result in personal injury or property damage.

Contact your retail store for missing or damaged parts.

1. Check to see that you have received the following parts:

NOTE: If you are uncertain of part description, refer to exploded view illustration.

Hanger Bracket

Ceiling Canopy (1)

Assembly (1)

Canopy Screw Cover

Assembly (1)

Downrod/Hanger Ball

Assembly (1)

– Downrod (1)

– Hanger Ball (1)

Motor Coupling

– Set Screw (1)

Cover Assembly (1)

– Hairpin Clip (1)

– Clevis Pin (1)

– Pin (1)

Hardware Bags

Truss Head Screws M4

Spring Washers

(6)

install, operate and maintain your ceiling fan

• One stepladder

• One wire stripper