How To Assemble Your Ceiling Fan - Fanimation KLOUT FP3070 Serie Manual De Instrucciones

How to Assemble Your Ceiling Fan

1.
Remove the hanger ball portion from the downrod/
hanger ball assembly by loosening the set screw in
the hanger ball until the ball falls freely down the
downrod. Remove the pin from the downrod, then
remove the hanger ball. Retain the pin and hanger ball
for reinstallation in Step 7. (Figure 1)
2.
Remove the hairpin clip and clevis pin from the
bottom of the downrod. Retain the pin and clip for
reinstallation in Step 5. (Figure 2)
3. Assemble the support arms of the motor assembly
to upper grill assembly using the truss head screws,
spring washers and acorn nuts. Make sure the screws
securing the support arms to the upper grill assembly
are tight and properly seated. (Figure 3)
4. Loosen the two set screws and locking nuts in the
downrod support of the motor assembly. Route the
black, white, blue wires and safety cable through
the downrod. (Figure 4)
Downrod
Set Screw
Hairpin Clip
Support Arms
HARDWARE USED:
Truss Head Screws M4
Spring Washers
Acorn Nuts M4
Set Screws and
Locking Nuts (2)
7
Pin
Hanger Ball
Figure 1
Clevis Pin
Figure 2
Truss Head Screw M4
Spring Washer
Acorn Nut M4
Upper Grill Assembly
Figure 3
x 5
x 5
x 5
Black, White, Blue wires
and Safety Cable
Figure 4