Fanimation KLOUT FP3070 Serie Manual De Instrucciones página 8

How to Assemble Your Ceiling Fan (Continued)
5. Slide downrod into the downrod support on top of
the motor. Install the clevis pin by aligning the holes
in the downrod support with holes in the downrod.
Secure clevis pin with hairpin clip. Install and tighten
the two set screws with nuts in the downrod support.
(Figure 5)
WARNING
It is critical that the clevis pin in the downrod support
is properly installed and the set screws and nuts are
securely tightened. Failure to do so could result in the
fan falling.
6. Route wires and safety cable through motor
coupling cover, canopy screw cover and ceiling
canopy. (Figure 6)
7. Reinstall the hanger ball on the downrod as follows.
Route the black, white, blue wires and safety cable
through the hanger ball. Position the pin through
the two holes in the downrod and align the hanger
ball so the pin is captured in the groove in the top
of the hanger ball. Pull the hanger ball up tight
against the pin. Securely tighten the set screw in the
hanger ball. A loose set screw could create fan
wobble. (Figure 7)
8. Cut off excess lead wire approximately 6 to 9 inches
above top of the downrod. Strip insulation off 1/2 inch
from the end of each lead wire. (Figure 8)
CAUTION
All set screws must be checked, and retightened where
necessary before installation.
9. Remove one of the two shoulder screws in the
hanger bracket and retain the screw for later. Loosen
the second shoulder screw without fully removing it.
(Figure 9)
Downrod
Hairpin Clip
Clevis Pin
Ceiling Canopy
Canopy Screw
Cover
Hanger Bracket
8
Set Screws and
Locking Nuts (2)
Figure 5
Motor Coupling
Cover
Figure 6
Figure 7
Figure 8
Figure 9