V2 FORTECO 2500-I Manual Del Usuario página 45

4. Pour the concrete and position the anchoring plate
WARNING: check that the plate be on a perfectly levelled surface and parallel to the gate
5. Wait for the complete setting of the concrete
6. Unscrew the bolts fixing the base to the clamps and put the motor on the plate
7. Insert the 4 grains with their nuts in the proper place. Adjust the 4 grains to make the motor be perfectly levelled
8. Control that the motor is perfectly parallel to the gate, then insert the 4 washers R and lightly screw the 4 bolts D
WARNING: put the washer G into the hole for the passing of the cables as shown in the picture. Pierce the washer to let the cable
to be connected to the control unit pass, paying attention to the dimensions in order to avoid the entrance of insects and other small
animals.
43