Inspection And Maintenance - SafeWaze OSHA 1910 Manual Del Usuario

User Manual

12.0 Inspection and Maintenance

Inspection
Inspect the Tensioner for corrosion and/or damage.
.
Inspect both the webbing of Cross Arm Straps (if being used) and for cuts, abrasions
and contamination.
Check carabiners for proper operation, signs of corrosion, distortion or damage.
Inspect the cable for damage including but not limited to corrosion, welding spatter,
birdcaging, kinks, broken strands, or chemical exposure
Frequency
All components of the SafeWaze Cable Horizontal Lifeline must be inspected prior to
each use, and annually by a "competent person" (other than the user), as defined by
OSHA.
Criteria
If inspection reveals any defect, inadequate maintenance, or unsafe condition, remove
from service until a "qualified person" as defined by OSHA 1926.32(m) can determine
the need for authorized repair or disposal.
Maintenance
Any SafeWaze Cable Horizontal Lifeline components requiring maintenance must be
tagged "unusable" and removed from service.
Cleaning maintenance may be performed by the user.
Repairs to the product may only be made by the manufacturer or entities authorized in
writing by the manufacturer.
THIS DEVICE MUST ONLY BE SERVICED BY A TRAINED AND COMPETENT INDIVIDUAL!
NEVER ATTEMPT TO SERVICE THIS UNIT OR TAMPER WITH ITS FUNCTION IN ANY WAY!
Storage
When not installed, the SafeWaze Horizontal Lifeline should be stored in a cool, dry
place out of direct sunlight. Do not store in areas where damage from environmental
factors such as heat, light, excessive moisture, oil, chemicals and their vapors, or other
degrading elements may be present. Do not store damaged equipment or equipment
in need of maintenance in the same area as product approved for use. Equipment that
has been stored for an extended period must be inspected as described in these User
Instructions prior to use.
Page 19
V1.4 2019 Copyright SafeWaze