Operation Instruction; Select The Programme; Programme End - EAS ELECTRIC EMTD8HP Manual

Operation instruction

Select the programme

1.Press the【On/Off 】 button ,when the working state LED brighten up, rotate the programme
knob to select the desired programme.
2.Select the【Delay】,or【Anti-Crease】functions for additional option.
3.Press the【Start/Pause】button.
Programme start
The drum will keep rotating after the programme start, the
Note:
Occasionally , the drum might suspend about 40 seconds during the drying procedure, but the
working state LED flashe normal. The dryer is automatic adjustment in this time and will continue
operation.

Programme end

1.The drum will stop running after the programme ends, the working state LED will stay
light and buzzer will ring. The "Filter" and "Full" LED will remind user to clean the filters
and container. The dryer will start 【 Anti-crease
remove the load in time (refer to page 15). Please press
and pull the plug out.
2.Deal with the problem accroding to "Malfunction display and solutions , if there is a
unexpected stop during the drying procedure and the dryer show information(refer to
page 18 ).
V.1
working state LED will flash in sequence.
6
】 function if user doesn't
【On/Off】
key to cut off power
"
12
Note:1. This symbol means the energy efficiency test programme "standard cotton programme", which is most
suitable to dry normal cotton load at rated load capacity.
2.The programmes above are only recommended for using, users can choose the appropriate programme
according to the personal habits. Thick and multi-layered farics,e.g. bedlinen, jeans, jackets etc, are not easy
to dry, you'd better choose Jeans programme and maximum drying intensity level.
3. As the uneven material, thick and multi-layered clothes are not easy to dry, it is better to choose the appropriate
time drying programme to dry them if some parts of the clothes still damp after programme finished.
13
V.1