ZAMST FILMISTA ANKLE Instrucciones De Uso página 2

How to apply
• Before attaching this product, carefully read the "Precautions for use - Be sure to read this" section. Then follow the steps provided to ensure the
product is correctly attached.
• The steps below use the right foot for reference. Follow the same steps for the left foot.
1.
Unfasten all the hook-and-loop fasteners of the product.
Confirm the inside/outside and front/back of the product.
Logo mark
<Outside of the product>
Hook-
and-loop
Hook-and-loop
fastener A
fastener B
Tag
<Inside of the product>
2.
Apply the product to the inner ankle bone.
Make sure that the inner ankle bone mark on the back of the
anchor is aligned to the inner ankle bone.
3.
Wrap the anchor part around your ankle and fasten
hook-and-loop fastener A.
Hook-
and-loop
fastener A
Disclaimer:
* The product specifications and appearance are subject to change without notice for the purpose of improvement.
* When disposing of this product, be sure to follow all disposal ordinances and regulations as specified by the local government.
* We take all possible measures to ensure product quality, however, if you find any defects, etc. in our products, please contact Nippon Sigmax Co., Ltd.
"ZAMST" and "ZAMST logo" are trademarks or registered trademarks of Nippon Sigmax Co., Ltd in Japan, the United States and other countries.
Anchor
Apply the side with the
size tag on the back of
the anchor to your ankle.
Hook-
and-loop
fastener C
Hook-
and-loop
fastener D
Inner ankle bone
mark
Pull the product keeping
the position of the inner
ankle bone mark in place
and tightly wrap your
ankle without creating
wrinkles or sags.
4.
Pull the product with your foot at right angles to your lower
leg and with the heel pushed outward, pull hook-and-loop
fastener C up and over the outer ankle bone and fasten it.
Hook-
and-loop
fastener C
Outer ankle
bone
5.
Pull up hook-and-loop fasteners B and D until the
required compression is created, and wrap them around
the ankle and fasten them.
Hook-
and-loop
fastener B
6.
Make sure that the product is not loose or out of place.
If you feel any discomfort, repeat the steps from the
beginning to reattach the product.
The product correctly fastened (right foot)
<Front view>
<Inner side view>
[TIP]
The product can be
applied tightly around
your ankle by pushing it
with your feet crossed.
If you cannot pull hook-
and-loop fastener C
above the outer ankle
bone, pull the product up
while stretching it again.
Hook-
and-loop
fastener D
Refasten hook-and-
loop fasteners B and
D repeatedly until the
required compression is
created. If hook-and-
loop fasteners B and D
overlap each other, place
them up and down.
<Back view>
<Outer side view>